Mold storage is usually treated as routine upkeep. Teams clean the tool, dry it and apply protective oil before putting it away. The resin that ran in the previous job can change...
Category: Repair & Troubleshooting
Explore mold repair and troubleshooting methods for tooling wear, surface damage, ejector problems, poor venting, sticking and molding defects.
How Can Vent Clogging Be Distinguished From Poor Filling
A short shot on a molded part rarely announces its cause. Missing edges, short corners, shallow sections, and unfinished ribs can come from a melt that never had the flow to get...
How Does Resin Residue Cause Repeated Mold Defects
Resin residue inside an injection mold can cause a defect that comes and goes with no obvious pattern. One cycle gives a clean part. The next shows a dull patch or a...
Why Does Flash Appear After Mold Alignment Changes
Flash can appear after mold alignment work even when the molding conditions have not changed. A thin edge of material may suddenly remain around the parting line, near an insert area, or...